TM 5-3805-280-24-2
Cylinder Block, Liners, Pistons and Rods
10
5. Turn cylinder liner (B) upside-down. Dip square
54
packing (A) in soap and install over outside of liner.
6. Slide packing down firmly against shoulder on liner.
Make sure packing is not twisted.
7. Coat the liner packing sealing area of the cylinder liner
and block O-rings with liquid soap.
A--Square Packing
B--Cylinder Liner
RG,10,DT7391 1911NOV972/2
INSTALL CYLINDER LINER IN BLOCK
IMPORTANT: Install cylinder liners into same cylinder
block bore as removed. DO NOT scuff
the liner packing across the upper
counterbore.
Pitted or eroded liners that meet reuse
guidelines should be rotated 90 from
their removed position. (See VISUALLY
INSPECT CYLINDER LINERS earlier in
this group for reuse guidelines.)
1. Install liner in block bore with mark (made during
disassembly) toward front of engine, unless liner OD is
pitted or eroded.
If liner OD is pitted or eroded, but still within
acceptable service limits, rotate liner 90 from its
removed position. Pitted sections of the liner should be
facing the front or rear of engine.
Continued on next page
RG,10,DT7390 1911NOV971/2
13-167
