TM 5-3805-281-24-2
Speed Controls
REMOVE AND INSTALL ENGINE SPEED CONTROL CABLE
05
0515
8
A--Ball Joint (2 used)
C--Speed Control Cable
E--Lock Washer (2 used)
G--Bracket
B--Nut (2 used)
D--Bracket
F--Nut (2 used)
H--Injection Pump Lever
cable are centered in brackets. As needed, adjust
IMPORTANT: The ball joints (A) are installed on
cable in brackets to connect ball joint to lever or
the cable to full thread engagement.
arm.
A ball joint can be used to lengthen
a cable end, if needed, but must
3. Connect ball joint to engine control motor arm.
have at least 6 mm (1/4 in.) of thread
engagement to avoid stripping the
4. Do Engine Control Motor Adjustment and Sensor
threads on cable end.
and then the Engine Speed Learning Procedure.
(See procedures in this group.)
1. Install ball joints (A) to full thread engagement.
Tighten nuts.
2. Install speed control cable (C) in brackets (D and
G). Initially, tighten nuts so threaded portions of
CED,OUOE024,219
1912SEP981/1