TM 5-3805-281-24-2
Speed Controls
REMOVE AND INSTALL ENGINE CONTROL MOTOR
05
0515
9
A--Cap Screw
C--Bracket
E--Connector (4-Wire)
G--Cap Screw (3 used)
B--Bracket
D--Motor Assembly
F--Connector (3-Wire)
H--Arm
NOTE: The engine control angle sensor is located
7. Repair or replace as necessary.
inside the engine control motor housing. The
sensor is serviced as an assembly with the
8. Install motor assembly (D) on bracket (B). Tighten
engine control motor.
cap screws (G).
9. Install arm (H) on motor assembly (D).
1. Remove engine speed control cable at engine
control motor. (See procedure in this group).
10. Install brackets (B and C). Tighten cap screws (A).
2. Disconnect connectors (E and F).
11. Install engine speed control cable at engine
control motor. (See procedure in this group).
3. Remove cap screw (A) and brackets (B and C).
Remove bracket and motor assembly.
12. Adjust arm (H) so speed control cable is
horizontal.
4. Remove arm (H) from motor assembly (D).
13. Do Engine Control Motor and Sensor Adjustment
5. Remove cap screws (G).
and then the Engine Speed Learning Procedure.
(See procedures in this group.)
6. Remove motor assembly (D) from bracket (B).
TX,05,GG2306 1908SEP981/1