TM 5-3805-281-24-2
Speed Controls
ENGINE CONTROL MOTOR AND SENSOR
ADJUSTMENT
When the following components are repaired or replaced,
or when engine speeds deviate from specification, the
engine control motor and sensor adjustment and engine
speed learning procedure must be performed. (See
procedures in this group.)
Engine
Engine speed control cable
Engine control motor and sensor
Engine and pump controller
Fast and slow idle stops
1. Check that the fast idle and slow idle stop screws on
the injection pump are adjusted to specification. (See
Injection Pump Fast and Slow Idle Stops Adjustment in
this group.)
2. Turn key switch to ON.
05
0515
3. Turn the engine rpm dial to slow idle.
10
CED,OUOE003,1085
1908SEP981/2
4. Loosen cap screw (A) in engine control motor arm (B).
5. Adjust the arm (B) on the shaft so the injection pump
lever just contact the slow idle stop screw.
6. Tighten cap screw (A).
Engine Control Motor Arm Cap Screw--Specification
Torque ........................................................................... 13 Nm (115 lb-in)
7. Do Engine Speed Learning Procedure in this group.
A--Cap Screw
B--Arm
CED,OUOE003,1085
1908SEP982/2
