TM 5-3805-294-23-1
0108
Table 1. DTC 3510.04 - Sensor Supply #2 Voltage Out Of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
Measure resistance (Volume
1.
If any measurement was less
14.
Short Circuit
than 10 ohms, replace engine
Between Engine
3, WP 0369) between engine
wiring harness (Volume 4,
Wiring Harness
wiring harness connector J01
Connector J01
socket H4 (Volume 5,
WP 0510) and replace engine
Socket H4 and All
interface wiring harness.
WP 0800, Figure 48) and all
Other Sockets On
other sockets on engine
(Volume 4, WP 0509) Restore
Engine Interface
interface wiring harness
machine to original condition
Wiring Harness
connector J02. (Volume 5,
and perform Harness
Connector J02.
Diagnostic Mode Test.
WP 0800, Figure 47) Note
readings.
(Volume 3, WP 0345)
2.
If all measurements were
greater than 10 ohms,
reconnect all connectors and
proceed to Malfunction 1.
END OF WORK PACKAGE
0108-7/8 blank