TM 5-3805-294-23-1
0108
Table 1. DTC 3510.04 - Sensor Supply #2 Voltage Out Of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
Measure resistance (Volume
1.
If any measurement was less
11.
Short Circuit
than 10 ohms, replace engine
Between Engine
3, WP 0369) between engine
wiring harness. (Volume 4,
Wiring Harness
wiring harness connector J03
Connector J03
socket A3 and all other sockets
WP 0510) Restore machine to
Socket A3 and All
on engine wiring harness
original condition and perform
Other Sockets On
connectors J03 (Volume 5,
Harness Diagnostic Mode
Engine Wiring
WP 0800, Figure 48) and
Test. (Volume 3, WP 0345)
Harness
J01. (Volume 5, WP 0800,
2.
If all measurements were
Connectors J01 and
Figure 46) Note readings.
greater than 10 ohms, proceed
J03.
to Malfunction 12.
1.
Disconnect engine interface
12.
Short Circuit
wiring harness connector J02.
Between Engine
Wiring Harness
(Volume 5, WP 0800, Figure
Connector J03
47)
Socket A3 and All
Other Sockets On
Engine Interface
Wiring Harness
Connector J02.
2.
Measure resistance (Volume
1.
If any measurement was less
than 10 ohms, replace engine
3, WP 0369) between engine
wiring harness (Volume 4,
wiring harness connector J03
socket A3 (Volume 5,
WP 0510) and replace engine
interface wiring harness.
WP 0800, Figure 48) and all
other sockets on engine
(Volume 4, WP 0509) Restore
interface wiring harness
machine to original condition
connector J02. (Volume 5,
and perform Harness
Diagnostic Mode Test.
WP 0800, Figure 47) Note
(Volume 3, WP 0345)
readings.
2.
If all measurements were
greater than 10 ohms,
reconnect all connectors and
proceed to Malfunction 13.
Measure resistance (Volume
1.
If any measurement was less
13.
Short Circuit
than 10 ohms, replace engine
Between Engine
3, WP 0369) between engine
wiring harness. (Volume 4,
Wiring Harness
wiring harness connector J01
Connector J01
socket H4 and all other sockets
WP 0510) Restore machine to
Socket H4 and All
on engine wiring harness
original condition and perform
Other Sockets On
connectors J03 (Volume 5,
Harness Diagnostic Mode
Engine Wiring
WP 0800, Figure 48) and
Test. (Volume 3, WP 0345)
Harness
J01. (Volume 5, WP 0800,
2.
If all measurements were
Connectors J01 and
Figure 46) Note readings.
greater than 10 ohms, proceed
J03.
to Malfunction 14.
0108-6