TM 5-3805-294-23-1
FIELD MAINTENANCE
DTC 3510.04 - SENSOR SUPPLY #2 VOLTAGE OUT OF RANGE LOW
INITIAL SETUP:
References (cont.)
Tools and Special Tools
Tool Kit, General Mechanic's: Automotive
Volume 3, WP 0362
(Volume 5, WP 0796, Table 2, Item 119)
Volume 3, WP 0369
Accessory Kit, MSD Electronic Equipment
Volume 3, WP 0417
(Volume 5, WP 0796, Table 2, Item 2)
Volume 3, WP 0431
Multimeter, Digital
Volume 4, WP 0508
(Volume 5, WP 0796, Table 2, Item 77)
Volume 4, WP 0509
Probe Set, Standard
Volume 4, WP 0510
(Volume 5, WP 0796, Table 2, Item 91)
Volume 4, WP 0511
Test Set, MSD Electronic Systems
Volume 4, WP 0593
(Volume 5, WP 0796, Table 2, Item 116)
Volume 5, WP 0800
Personnel Required
Equipment Condition
Construction Equipment Repairer 91L (2)
Machine safely parked and shut down (TM
5-3805-294-10). (Volume 5, WP 0794)
Test Equipment Setup for MSD and Service
References
ADVISOR. (Volume 3, WP 0375)
TM 5-3805-294-10 (Volume 5, WP 0794)
Volume 3, WP 0345
Troubleshooting Sequence
DTC 3510.04
When DTC is Displayed
Whenever the ignition is on and the error is active.
Related Information
The ECU detects a supply voltage lower than 4.59 volts on the Sensor Supply #2 circuit.
There are two outputs from this supply. One from J01 and the other from J03. The outputs on J01 are currently not
connected to any components.
Alarm Level
Warning.
Sensors Using Sensor Supply #2 Voltage from ECU connector J01:
Currently None.
Sensors Using Sensor Supply #2 Voltage from ECU connector J03
Fuel Transfer Pump Pressure Sensor.
0108-1