TM 5-3805-294-23-1
0107
Table 1. DTC 3510.03 - Sensor Supply #2 Voltage Out Of Range High - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Measure resistance (Volume
1.
If any measurement was less
than 10 ohms, replace engine
3, WP 0369) between engine
wiring harness (Volume 4,
wiring harness connector J03
socket H4 (Volume 5,
WP 0510) and replace engine
interface wiring harness.
WP 0800, Figure 48) and all
other sockets on engine
(Volume 4, WP 0509) Restore
interface wiring harness
machine to original condition
connector J02. (Volume 5,
and perform Harness
Diagnostic Mode Test.
WP 0800, Figure 47) Note
readings.
(Volume 3, WP 0345)
2.
If all measurements were
greater than 10 ohms,
reconnect all connectors and
proceed to Malfunction 1.
END OF WORK PACKAGE
0107-4