TM 5-3805-294-23-1
0108
Table 1. DTC 3510.04 - Sensor Supply #2 Voltage Out Of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
Measure resistance (Volume
1.
If less than 10 ohms, replace
5.
Oil Pressure Sensor
oil pressure sensor. (Volume
Shorted to Ground.
3, WP 0369) between each
terminal of oil pressure sensor
3, WP 0417) Restore machine
and a known good ground.
to original condition and
perform Harness Diagnostic
(Volume 5, WP 0800, Figure
Mode Test. (Volume 3,
56) Note reading.
WP 0345)
2.
If greater than 10 ohms,
proceed to Malfunction 6.
Measure resistance (Volume
1.
If less than 10 ohms, replace
6.
Fuel Transfer Pump
fuel transfer pump pressure
Pressure Sensor
3, WP 0369) between each
Shorted Internally.
terminal of fuel transfer pump
sensor. (Volume 3, WP 0431)
pressure sensor. (Volume 5,
Restore machine to original
condition and perform Harness
WP 0800, Figure 55) Note
Diagnostic Mode Test.
reading.
(Volume 3, WP 0345)
2.
If greater than 10 ohms,
proceed to Malfunction 7.
Measure resistance (Volume
1.
If less than 10 ohms, replace
7.
Fuel Transfer Pump
fuel transfer pump pressure
Pressure Sensor
3, WP 0369) between each
Shorted to Ground.
terminal of fuel transfer pump
sensor. (Volume 3, WP 0431)
pressure sensor to a known
Restore machine to original
good ground. (Volume 5,
condition and perform Harness
Diagnostic Mode Test.
WP 0800, Figure 55) Note
reading.
(Volume 3, WP 0345)
2.
If greater than 10 ohms,
proceed to Malfunction 8.
Visually inspect engine wiring
1.
If damaged, replace engine
8.
Engine Wiring
harness for pinched or melted
wiring harness. (Volume 4,
Harness Damaged.
wires between engine wiring
WP 0510) Restore machine to
harness connector P04
original condition and perform
(Volume 5, WP 0800, Figure
Harness Diagnostic Mode
56) and engine wiring harness
Test. (Volume 3, WP 0345)
connector J03 (Volume 5,
2.
If not damaged, proceed to
WP 0800, Figure 48) and
Malfunction 9.
between engine wiring
harness connector I01
(Volume 5, WP 0800, Figure
44) and engine wiring harness
connector J03.
0108-4