TM 5-3805-294-23-1
0108
Table 1. DTC 3510.04 - Sensor Supply #2 Voltage Out Of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
7.
Turn key switch to OFF
1.
If DTC 3510.04 is still an active
position (TM 5-3805-294-10).
DTC, proceed to Malfunction
9.
(Volume 5, WP 0794)
2.
If DTC 3510.04 is a stored
DTC, proceed to Malfunction
2.
Visually inspect engine wiring
1.
If damaged or has loose
2.
Engine Wiring
harness connector P04
sockets, repair connector P04
Harness Connector
P04 is Damaged or
(Volume 5, WP 0800, Figure
(Volume 4, WP 0511) or
Has Loose Sockets.
56) for damage or loose
replace engine wiring
sockets.
harness. (Volume 4,
WP 0510) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged or does not
have loose sockets, proceed to
Malfunction 3.
Visually inspect engine wiring
1.
If damaged or has loose
3.
Engine Interface
harness connector P03
sockets, repair connector P03
Wiring Harness
Connector P03 is
(Volume 5, WP 0800, Figure
(Volume 4, WP 0511) or
Damaged or Has
55) for damage or loose
replace engine interface wiring
Loose Sockets.
sockets.
harness. (Volume 4,
WP 0509) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged or does not
have loose sockets, proceed to
Malfunction 4.
Measure resistance (Volume
1.
If less than 10 ohms, replace
4.
Oil Pressure Sensor
oil pressure sensor. (Volume
Shorted Internally.
3, WP 0369) between each
terminal of oil pressure
3, WP 0417) Restore machine
to original condition and
sensor. (Volume 5, WP 0800,
perform Harness Diagnostic
Figure 56) Note reading.
Mode Test. (Volume 3,
WP 0345)
2.
If greater than 10 ohms,
proceed to Malfunction 5.
0108-3