TM 5-3805-294-23-1
0108
Table 1. DTC 3510.04 - Sensor Supply #2 Voltage Out Of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
Visually inspect engine
1.
If damaged, replace engine
9.
Engine Interface
interface wiring harness for
wiring harness. (Volume 4,
Wiring Harness
pinched or melted wires
Damaged.
WP 0510) Restore machine to
between engine wiring
original condition and perform
harness connector P03
Harness Diagnostic Mode
(Volume 5, WP 0800, Figure
Test. (Volume 3, WP 0345)
55) and engine interface wiring
2.
If not damaged, proceed to
harness connector I01.
Malfunction 10.
(Volume 5, WP 0800, Figure
44)
1.
Verify key switch is in OFF
10.
Check For DTC
position (TM 5-3805-294-10).
3510.04 Active
Status Change With
(Volume 5, WP 0794)
Engine Wiring
Harness
Connectors J03 and
J01 Disconnected.
2.
Disconnect engine wiring
harness connectors J01
(Volume 5, WP 0800, Figure
46) and J03 from ECU.
(Volume 5, WP 0800, Figure
48)
3.
Turn key switch to ON position,
but DO NOT START ENGINE
(TM 5-3805-294-10). (Volume
5, WP 0794).
4.
Clear and refresh DTCs. Many
new DTCs will be active, only
note if DTC 3510.04 is still an
active DTC. (Volume 3,
WP 0362)
5.
Turn key switch to OFF
1.
If DTC 3510.04 is still an active
position (TM 5-3805-294-10).
DTC, replace ECU. (Volume 4,
(Volume 5, WP 0794)
WP 0508)
2.
If DTC 3510.04 is not an active
DTC, proceed to Malfunction
11.
0108-5