TM 5-3805-294-23-1
0129
Table 1. Glow Plug Check - Continued.
Test or Inspection
Corrective Action
Malfunction
Measure resistance (Volume
1.
If less than 10 ohms, replace
37.
Open Circuit
fuel temperature sensor
Between Engine
3, WP 0369) between engine
Wiring Harness
wiring harness connector T05
(Volume 3, WP 0430) and
Connector T05
proceed to Malfunction 38.
socket 1 (Volume 5, WP 0800,
Socket 2 and
Figure 70) and engine wiring
2.
If greater than 10 ohms,
Engine Wiring
harness connector J03 socket
replace engine wiring
Harness Connector
H3. (Volume 5, WP 0800,
harness. (Volume 4,
J03 Socket H3.
Figure 48) Note reading.
WP 0510) Reconnect all
connectors and proceed to
Malfunction 23.
1.
Reconnect engine wiring
38.
Fuel Temperature
harness connector T05 to fuel
Accuracy Check.
temperature sensor. (Volume
5, WP 0800, Figure 70)
2.
Turn key switch to ON position,
but DO NOT START ENGINE
(TM 5-3805-294-10). (Volume
5, WP 0794)
3.
Select Readings and select
Connect to Model(s). (Volume
3, WP 0363)
4.
Select Dearborn Protocol
Adapter (DPA 4+) USB for the
Readings Adapter, and select
OK. (Volume 3, WP 0363)
5.
Select Engine Control Unit
(ECU) Only. (Volume 3,
WP 0363)
6.
Under Connected Data Points,
select ECU - (shown with
engine serial number).
(Volume 3, WP 0363)
7.
Under ECU - (shown with
engine serial number), select
ECU - Data List - All. (Volume
3, WP 0363)
8.
Under ECU - Data List - All,
select Fuel Temperature.
(Volume 3, WP 0363)
0129-15