TM 5-2420-230-24-1
a. Removal.
(1)
Rotate tensioner clockwise.
(2)
Remove belt and slowly release tensioner.
b. Inspection.
Using clean cloth, ensure all belt grooves in
pulleys are clean and free from small particles of
rubber belting.
c. Installation.
(1)
Rotate tensioner clockwise.
NOTE
The drive belt and pulleys are 8 groove,
except for the air conditioner compressor
pump pulley which has 10 grooves. When
installing the drive belt, ensure that 1 groove
on this pulley is visible on both sides of the
drive belt.
(2)
Install drive belt around pulleys and slowly
release tensioner.
d. Follow-On Maintenance.
(1)
Start engine and inspect drive belt to ensure
belt is running in correct alignment
(2)
Shut OFF engine (TM 5-2420-230-10).
(3)
Close hood (TM 5-2420-230-10).
(4)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
Change 1
4-7