TM 5-2420-230-24-1
(64) Place power pack assembly on power pack stand.
(65) Remove adjustable sling and lifting device.
b. Inspection.
NOTE
Ensure all hoses, wires, and tubes are reconnected to positions noted prior to removal.
Install cable ties as necessary.
(1)
Ensure engine bay of IHMEE is prepared to accept engine and transmission.
(2)
Ensure all electrical cables and connections are routed clear of where engine and transmission assembly will sit.
(3)
Ensure no loose items are in engine bay.
(4)
Inspect engine and transmission mounts on chassis for wear, damage, and contamination. Replace any
unserviceable mounts.
c. Installation.
The engine and transmission assembly weighs approximately 1 ton (907 kg). To avoid the possibility
of personal injury, loss of life, and the destruction of the vehicle, only a qualified person using
certified lifting equipment is to carry out slinging operations involving the IHMEE. Failure to comply
may result in injury or death to personnel.
(1)
Attach adjustable sling and lifting device to
power pack lifting eyes with a capacity for
combined weight of engine and
transmission.
(2)
Use lifting device to remove power pack
assembly from engine stand.
NOTE
Do not lower engine and transmission fully
onto mounts.
(3)
Carefully maneuver power pack assembly
into engine bay so mounting holes align with
engine and transmission mounts.
(4)
Install four bolts, new lockwashers, and two mounts on transmission.
Change 1
4-16
