TM 5-2420-230-24-1
NOTE
Ensure all hoses, wires, and tubes are
reconnected to positions noted prior to
removal.
Install cable ties as necessary.
Ensure steering lines and hoses are clean and
contain no foreign matter.
(0.1) Apply Loctite 567 to 90-degree elbow (5) and
nipple (7).
(1)
Install 90-degree elbow (5) and nipple (7) on
power steering pump (12).
(2)
Install bolts (10), new lockwashers (11), new
gasket (11.1), and power steering pump (12) on
air compressor (13). Torque bolts to 23 lbf/ft
(31 Nm).
(2.1) Apply Loctite 567 to hose assemblies (4), (6),
and (8).
(3)
Install hose assembly (8) on 90-degree elbow (9).
(4)
Install hose assembly (6) on nipple (7).
(5)
Install hose assembly (4) on 90-degree elbow (5).
(6)
Install hose assembly (2) on nipple (3).
c. Follow-On Maintenance.
(1)
Ensure power steering fluid reservoir is filled with clean oil (Para 5-5).
(2)
Bleed power steering system (Para K-3).
Do not check for leaks by hand; oil under hydraulic pressure can penetrate the skin and cause severe
injury. Failure to comply may result in injury or death to personnel.
(3)
Start engine and check for leaks (TM 5-2420-230-10).
(4)
Functionally test power steering pump (TM 5-2420-230-10).
(5)
Lower hood (TM 5-2420-230-10).
(6)
Shut OFF engine (TM 5-2420-230-10).
(7)
Remove maintenance arm and lower FEL (TM 5-2420-230-10).
(8)
Install left fender (Para 13-16).
END OF TASK
Change 1
5-15