TM 5-2420-230-24-1
6-3. RESTORE IHMEE TO OPERATIONAL READINESS.
Upon completion of maintenance activities, restore power and return vehicle to operational readiness using the following
procedure:
(1)
Place electrical master switch in ON position (TM 5-2420-230-10).
(2)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
(3)
Ensure parking brake is applied (TM 5-2420-230-10).
(4)
Start engine (TM 5-2420-230-10).
(5)
Raise FEL, remove maintenance arm, and lower FEL to ground or travel position, as required
(6)
Complete necessary documents and return IHMEE to relevant authority.
6-4. CHECK STRAP REPLACEMENT.
This Task Covers:
a. Inspection
b. Removal
c. Installation
d. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Equipment Conditions
None
TM or Para
Condition Description
Vehicle positioned on level
ground.
Tools and Special Tools
Tool kit, common no. 2, Item 36, Appendix B
Parking brake applied.
Tool kit, general mechanics, Item 38, Appendix B
Engine shut OFF.
Electrical master switch OFF.
"Do Not Operate" tag attached
Materials/Parts
Nut, self-locking, Item 123, Appendix D (2)
to ignition switch.
Personnel Required
Drawings Required
MOS 62B, Construction Equipment Repairer
TM 5-2420-230-24P Figure 114
References
Estimated Time to Complete
None
Refer to MAC in Appendix B
Change 1