TM 5-2420-230-24-1
b. Installation.
NOTE
Ensure clamp, U-bolts, and steering damper clears axle center and drive shaft.
(1)
If required, install two U-bolts (14), clamp (6), four washers (13), and four new self-locking nuts (12) on tie
rod (15). Align clamp on tie rod with marks made previously. Tighten self-locking nuts.
(2)
If required, install crush sleeves (4) and (10) in steering damper (5).
(3)
Install steering damper (5), bolt (7), two washers (8), and new self-locking nut (9) on damper mount (11). Tighten
self-locking nuts.
(4)
Install damper (5), bolt (1), two washers (2), and new self-locking nut (3) on clamp (6). Tighten self-locking nut.
c. Follow-On Maintenance.
(1)
Lower vehicle (Para 2-21).
(2)
Start engine (TM 5-2420-230-10) and functionally test steering system (TM 5-2420-230-10).
(3)
Shut OFF engine (TM 5-2420-230-10).
(4)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
5-43/5-44 blank
Change 1