TM 5-2420-230-24-1
b. Installation.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are
harmful to skin and clothing. To avoid injury or death, keep away from fire and use in well-ventilated
area. If adhesive, solvents, or sealing compound get on skin or clothing, wash immediately with soap
and water. Failure to comply may result in injury or death to personnel.
NOTE
Ensure all hoses and tubes are reconnected to positions noted prior to removal.
Install cable ties as necessary.
Perform Steps (0.1) and (1) if removed.
(0.1) Apply sealing compound, Loctite 567, to threads of low coolant sensor (6) and adaptor (12).
(1)
Install low coolant sensor (6), adaptor (12), and
filler cap (13) on coolant reservoir (2).
(2)
Place coolant reservoir (2) on bracket.
(3)
Install three new self-locking nuts (9) and
washers (10) securing coolant reservoir (2) to
support bracket (11).
(4)
Install hose (8) and tighten hose clamp (7) on
bottom of coolant reservoir (2).
(5)
Connect electrical wire (5.1) to low coolant
sensor (6) on rear of coolant reservoir (2).
(6)
Install overflow hose (5) connecting to filler
neck on coolant tank reservoir (2).
(7)
Install hose (4) leading to thermostat housing.
(8)
Install hose (3) leading to radiator.
(9)
Tighten two hose clamps (1) on top of coolant
reservoir (2).
c. Follow-On Maintenance.
Fill cooling system (Para 9-4).
END OF TASK
9-12.1/9-12.2 blank
Change 1
