TM 5-2420-230-24-1
b. Installation.
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry or tools contact
positive electrical circuits, a direct short may
result. Damage to equipment and injury or
death to personnel may occur.
NOTE
Ensure all wires are reconnected to
positions noted prior to removal.
Install cable ties as necessary.
If vehicle has cold weather kit installed,
connect three wires to starter button.
(1)
Install two wires (7), washers (6), and screws (5) onto starter button (3).
(2)
Position starter button (3) in PDP (4).
(3)
Install washer (2) and nut (1) onto starter button (3).
c. Follow-On Maintenance.
(1)
Close PDP door (TM 5-2420-230-10).
(2)
Start engine to test starter button for proper operation (TM 5-2420-230-10).
(3)
Shut OFF engine (TM 5-2420-230-10).
(4)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
Change 1
12-41