TM 5-2420-230-24-1
a. Removal.
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment and injury or death to personnel may occur.
NOTE
Remove cable ties as necessary.
Ensure all wires are disconnected and
cleared before removal.
Left and right joysticks are removed in
the same way.
(1)
Remove four screws (1) from joystick (2).
(2)
Remove four screws (3) from operator's seat
arm (4) and remove bottom cover (5).
(3)
Disconnect electrical connector (6).
(4)
Remove joystick (2) from operator's seat
arm (4).
b. Installation.
NOTE
Ensure all wires are reconnected to positions noted prior to removal.
Install cable ties as necessary.
(1)
Install joystick (2) and four screws (1) in operator's seat arm (4).
(2)
Connect electrical connector (6).
(3)
Install bottom cover (5) to operator's seat arm (4) with four screws (3).
c. Follow-On Maintenance.
(1)
Start engine (TM 5-2420-230-10).
(2)
Perform hydraulic calibration (TM 5-2420-230-10).
(3)
Shut OFF engine (TM 5-2420-230-10).
(4)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
Change 1
12-44