TM 5-2420-230-24-1
12-22. STARTER BUTTON REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Equipment Conditions
None
TM or Para
Condition Description
Vehicle positioned on level
ground.
Tools and Special Tools
Tool kit, general mechanics, Item 38, Appendix B
Parking brake applied.
Engine shut OFF.
Electrical master switch OFF.
Materials/Parts
Tags, identification, Item 63, Appendix C
"Do Not Operate" tag attached
Ties, cable, Item 68, Appendix C
to ignition switch.
PDP door opened.
Personnel Required
Drawings Required
MOS 62B, Construction Equipment Repairer
TM 5-2420-230-24P Figure 48
References
Estimated Time to Complete Task
None
Refer to MAC in Appendix B
a. Removal.
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry or tools contact
positive electrical circuits, a direct short may
result. Damage to equipment and injury or
death to personnel may occur.
NOTE
Remove cable ties as necessary.
Tag all wires and note their positions
before removal.
(1)
Remove nut (1), washer (2), and starter
button (3) from PDP (4).
NOTE
If vehicle has cold weather kit, remove three wires from starter button.
(2)
Remove two screws (5), washers (6), and wires (7) from starter button (3).
Change 1