TM 5-2420-230-24-1
12-19. POWER DISTRIBUTION PANEL (PDP) ASSEMBLY REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Equipment Conditions
None
TM or Para
Condition Description
Remove belly plates, as
Tools and Special Tools
necessary.
Tool kit, general mechanics, Item 38, Appendix B
Parking brake control removed.
Materials/Parts
Rocker switches removed.
Cap and plug set, Item 4, Appendix C
Ignition switch removed.
Nut, self-locking, Item 103, Appendix D (4)
Starter button removed.
Sealant, Sikaflex 221, Item 55.1, Appendix C
Throttle control removed.
Tags, identification, Item 63, Appendix C
Auxiliary defroster switch
Ties, cable, Item 68, Appendix C
removed.
Ether start pushbutton removed
Personnel Required
(if equipped).
MOS 62B, Construction Equipment Repairer
Drawings Required
References
TM 5-2420-230-24P Figure 48
None
TM 5-2420-230-24P Figure 49
Estimated Time to Complete Task
Refer to MAC in Appendix B
a. Removal.
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry or tools contact
positive electrical circuits, a direct short may
result. Damage to equipment and injury or
death to personnel may occur.
NOTE
Tag all hoses, wires, and tubes and note
their positions before removal.
Remove cable ties as necessary.
Ensure all hoses, wires, and tubes are disconnected and clear before removal.
Cap and plug all tubes, hoses, and fittings upon removal.
(1)
Remove four nuts (1), washers (2), bolts (3), and fire extinguisher bracket (4).
Change 1