TM 5-2420-230-24-1
a. Removal.
(1)
Remove cotter pin (1) and pin (2) from
accelerator pedal (3). Discard cotter pin.
(2)
Remove four bolts (4) and washers (5) from
accelerator pedal (3).
(3)
Remove rubber boot (6) from accelerator
linkage (7).
b. Installation.
(1)
Insert accelerator linkage (7) into rubber
boot (6).
(2)
Install accelerator pedal (3) with four
bolts (4) and washers (5).
(3)
Install pin (2) and new cotter pin (1) in
accelerator pedal (3).
c. Follow-On Maintenance.
(1)
Start engine (TM 5-2420-230-10).
(2)
Test operation of accelerator pedal
(3)
Shut OFF engine (TM 5-2420-230-10).
(4)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
13-5. HAND THROTTLE REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
References
None
None
Tools and Special Tools
Equipment Conditions
Tool kit, general mechanics, Item 38, Appendix B
TM or Para
Condition Description
Center belly plate removed.
Materials/Parts
Ties, cable, Item 68, Appendix C
Drawings Required
TM 5-2420-230-24P Figure 43
Personnel Required
MOS 62B, Construction Equipment Repairer
Estimated Time to Complete Task
Refer to MAC in Appendix B
Change 1