TM 5-2420-230-24-1
13-8.1. INCLINOMETER REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Equipment Conditions
None
TM or Para
Condition Description
Vehicle positioned on level
ground.
Tools and Special Tools
Tool kit, general mechanics, Item 38, Appendix B
Parking brake applied.
Engine shut OFF.
Electrical master switch OFF.
Materials/Parts
Nut, self-locking, Item 126.1, Appendix D
"Do Not Operate" tag attached
to ignition switch.
Personnel Required
MOS 62B, Construction Equipment Repairer
Drawings Required
TM 5-2420-230-24P Figure 72
References
None
Estimated Time to Complete Task
Refer to MAC in Appendix B
a. Removal.
(1)
Remove two self-locking nuts (1), screws (2), and inclinometer (3) from bracket (4). Discard self-locking nuts.
(2)
If required, remove two screws (5) and bracket (4) from dash panel (6).
b. Installation.
(1)
If removed, install bracket (4) on dash panel (6) with two screws (5).
(2)
Install inclinometer (3) on bracket (4) with two screws (2) and new self-locking nuts (1).
c. Follow-On Maintenance.
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
Change 1