TM 5-2420-230-24-1
d. Follow-On Maintenance.
(1)
Close hood (TM 5-2420-230-10).
(2)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
14-9. FRONT AXLE HUB BREATHER REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Equipment Conditions
None
TM or Para
Condition Description
Vehicle positioned on level
ground.
Tools and Special Tools
Tool kit, general mechanics, Item 38, Appendix B
Parking brake applied.
Wheels turned to extreme lock.
Engine shut OFF.
Materials/Parts
None
Electrical master switch OFF.
"Do Not Operate" tag attached
to ignition switch.
Personnel Required
MOS 62B, Construction Equipment Repairer
Drawings Required
TM 5-2420-230-24P Figure 101
References
None
TM 5-2420-230-24P Figure 103
Estimated Time to Complete Task
Refer to MAC in Appendix B
a. Removal.
NOTE
Both sides remove and install the same way.
Left side is shown.
Unscrew breather cap (1) and remove cap.
b. Installation.
Install breather cap (1). Tighten.
c. Follow-On Maintenance.
Remove "Do Not Operate" tag from ignition
switch (TM 5-2420-230-10).
END OF TASK
14-15/14-16 blank