TM 5-2420-230-24-1
c. Follow-On Maintenance.
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
15-5. AIR VALVE REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
References
None
FO-5, Pneumatic schematic
Tools and Special Tools
Equipment Conditions
Tool kit, general mechanics, Item 38, Appendix B
TM or Para
Condition Description
Belly plates removed (if
required).
Materials/Parts
Tags, identification, Item 63, Appendix C
Air system drained.
Ties, cable, Item 68, Appendix C
Drawings Required
TM 5-2420-230-24P Figure 125
Personnel Required
MOS 62B, Construction Equipment Repairer
Estimated Time to Complete Task
Refer to MAC in Appendix B
a. Removal.
Ensure air pressure is drained to 0 psi (0 kPa) before taking off any air components. If pressure is not
released, components could blow off and harm personnel. The IHMEE air system is pressurized to
119 psi (820 kPa). Do not drain air from a tank with any part of body in air spray path. Skin embolisms
and/or debris in eyes can occur from released pressure. Failure to comply may result in injury or death
to personnel.
NOTE
All air valves are removed and installed in the same manner.
Remove cable ties as necessary.
Tag all hoses and tubes and note their positions before removal.
Cap and plug all tubes and fittings upon removal.
Change 1