TM 5-2420-230-24-1
a. Removal.
The stabilizer arms are heavy. To avoid personal injury, exercise extreme care when manually
handling the stabilizer arms. Failure to comply may result in injury or death to personnel.
Use care when removing or installing snap and retaining rings. Snap and retaining rings are under
spring tension and can act as projectiles when released and could cause severe eye injury.
Ensure pins are lubricated before installing. Failure to comply could result in damage to equipment.
(1)
Remove circlip (1) and pin (2) from
cylinder (3).
(2)
Attach suitable lifting device and sling to
cylinder (3).
(3)
Using lifting device and sling, raise
cylinder (3) and secure to cabin lifting eye.
(4)
Attach suitable lifting device and sling to
stabilizer arm (4).
(5)
Using lifting device and sling, take weight
off upper stabilizer pivot pin (5).
(6)
Remove two circlips (6), two washers (7),
and upper stabilizer pivot pin (5) from
stabilizer arm (4).
(7)
Using lifting device and sling, remove stabilizer arm (4).
b. Disassembly.
(1)
Remove two circlips (8), lower pivot pin (9), safety bracket (10), and two washers (11) from stabilizer arm (4) and
foot plate (12).
(2)
If required, remove bushings (13) from upper pivot on stabilizer arm (Para 17-6).
Change 1
16-3