TM 5-2420-230-24-1
17-3. RESTORE IHMEE TO OPERATIONAL READINESS.
Upon completion of maintenance activities, restore power and return vehicle to operational readiness using the following
procedure:
(1)
Place electrical master switch to ON position (TM 5-2420-230-10).
(2)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
(3)
Ensure parking brake is applied (TM 5-2420-230-10).
(4)
Start engine (TM 5-2420-230-10).
(5)
Raise FEL, remove maintenance arm, and lower FEL to ground or travel position as required
(6)
Complete necessary documents and return IHMEE to relevant authority.
The components listed above are of such a physical nature that routine maintenance requirements consist simply of a visual
inspection by the operator or maintenance personnel.
17-4. FRONT-END LOADER (FEL) ARM MAINTENANCE.
This Task Covers:
a. Removal
b. Disassembly
c. Inspection
d. Assembly
e. Installation
f. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Personnel Required
None
MOS 62B, Construction Equipment Repairer (2)
Tools and Special Tools
References
Adapter, pivot pin, Item 1, Appendix B
None
Field maintenance, basic, Item 23, Appendix B
Pan, drain, Item 29, Appendix B
Equipment Conditions
Tool kit, common no. 2, Item 36, Appendix B
TM or Para
Condition Description
Tool kit, general mechanics, Item 38, Appendix B
4-in-1 bucket removed.
Equipment, suitable lifting
Engine access panel removed.
Hydraulic pressure released.
Engine hood removed.
Materials/Parts
Cap and plug set, Item 4, Appendix C
FEL arm potentiometer
Dunnage, suitable
removed.
Grease, automotive and artillery, Item 30, Appendix C
Hose reel assembly removed.
Reflector, rectangular, amber,
Item 181, Appendix D (2)
Drawings Required
Tags, identification, Item 63, Appendix C
TM 5-2420-230-24P Figure 160
Ties, cable, Item 68, Appendix C
Estimated Time to Complete
Refer to MAC in Appendix B
Change 1