TM 5-2420-230-24-1
(3)
Install FEL arm rear pivot pins (11).
(4)
Install bolt (14) and nut (13) on each end of
rear pivot pin housing (15).
Use care when removing or installing snap
and retaining rings. Snap and retaining rings
are under spring tension and can act as
projectiles when released and could cause
severe eye injury.
(5)
Install washer (10) and circlip (9) on rear
pivot pin (11) for each FEL arm (12).
(6)
Remove cable ties securing FEL lift cylinder (8)
to chassis.
(7)
Secure travel stop and lift cylinder (8) by
aligning upper pivot pin (7) and travel stop.
(8)
Secure inside of upper pivot pin (7) to FEL lift
cylinder (8) with circlip (6) on each side of
vehicle.
(9)
Remove lifting device and sling.
(10) Connect two FEL hydraulic hoses located on
upper rear of FEL arm.
Change 1