TM 5-2420-230-24-1
(11) Connect wiring (1) for tilt-position
potentiometer (2).
(12) Position cushion clamp (5) on wire harness.
Install cushion clamp (5) with washer (4)
and bolt (3). Tighten bolt.
f. Follow-On Maintenance.
(1)
Install FEL arm potentiometer (Para 12-36).
(2)
Install engine hood (Para 13-19).
(2.1) Install hose reel assembly (Para 10-29).
(3)
Start engine and check for leaks (TM 5-2420-230-10).
(4)
Functionally test FEL arms (TM 5-2420-230-10).
(5)
Shut OFF engine (TM 5-2420-230-10).
(6)
Install engine access panel (TM 5-2420-230-10).
(7)
Install 4-in-1 bucket (TM 5-2420-230-10).
END OF TASK
17-5. CUTTING EDGE REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Equipment Conditions
None
TM or Para
Condition Description
TM 5-2420-230-10 Vehicle positioned on level
ground.
Tools and Special Tools
Tool kit, general mechanics, Item 38, Appendix B
TM 5-2420-230-10 Parking brake applied.
TM 5-2420-230-10 Engine shut OFF.
TM 5-2420-230-10 Electrical master switch OFF.
Materials/Parts
None
TM 5-2420-230-10 "Do Not Operate" tag attached to
ignition switch.
Personnel Required
MOS 62B, Construction Equipment Repairer (2)
Drawings Required
TM 5-2420-230-24P Figure 162
References
None
Estimated Time to Complete Task
Refer to MAC in Appendix B
Change 1