TM 5-3805-281-24-2
Hydraulic System
15. Install cap screw and nuts.
33
Tighten the nuts against each other, not the retainer.
3360
Cap screw must be free to turn in hole.
156
Arm Cylinder-to-Arm Pin M20 Cap Screw Nut--Specification
Torque ....................................................... 540 Nm (400 lb-ft) tighten nut
against nut, not the retainer
16. Lubricate all pivot joints. (See Track Adjuster,
Working Tool Pivot, Swing Bearing, and Swing
Bearing Grease in Group 0004.)
17. Bleed air from cylinder. (See procedure in this group.)
18. Check oil level in hydraulic oil tank. Add oil as
necessary. (See Hydraulic Oil in Group 0004.)
CED,OUOE026,10
1918JUN985/5
19-183