TM 5-3805-294-23-1
0115
Table 1. Engine Cranks/Will Not Start - Continued.
Test or Inspection
Corrective Action
Malfunction
4.
Turn key switch OFF position
(TM 5-3805-294-10). (Volume
5, WP 0794)
5.
Reconnect engine wiring
1.
If engine started, discontinue
harness connector X02 to
this troubleshooting procedure
high-pressure fuel pump
and perform procedure for
position sensor. (Volume 5,
DTC 636.02 (WP 0052) as
WP 0800, Figure 83)
though DTC was active.
2.
If engine did not start, proceed
to Malfunction 16.
Perform engine Compression
1.
If Compression Test results
16.
Service ADVISOR
indicate a significant difference
Compression Test.
Test (Volume 3, WP 0321) in
between cylinders or engine
Service ADVISOR. Note
cranked as though
readings.
compression was low in all
cylinders, proceed to
Malfunction 17.
2.
If Compression Test results did
not indicate a significant
difference between cylinders
or engine did not crank as
though compression was low
in all cylinders, proceed to
Malfunction 18.
Perform Engine Compression
1.
If compression test is within
17.
Mechanical Gauge
Test With Gauge. (Volume 3,
limits, proceed to Malfunction
Compression Test.
18.
WP 0328) Note readings.
2.
If pressure is too low, replace
cylinder head. (Volume 3,
WP 0407) Restore machine to
original condition.
3.
If pressure is too high, replace
engine. (Volume 3, WP 0410)
Restore machine to original
condition.
1.
Remove valve cover. (Volume
18.
Valves Out of
Adjustment.
3, WP 0453)
0115-8