TM 5-3805-294-23-1
0115
Table 1. Engine Cranks/Will Not Start - Continued.
Test or Inspection
Corrective Action
Malfunction
1.
Install battery covers. (Volume
6.
Engine Cranking
Speed Not
4, WP 0496)
Adequate.
2.
Perform Engine Cranking
1.
If test failed, discontinue this
Speed Test. (Volume 3,
troubleshooting procedure and
perform procedure for Engine
WP 0334) Note readings.
Will Not Crank. (WP 0123)
2.
If test passed, proceed to
Malfunction 7.
Perform Glow Plug Check.
1.
If check failed, repair fault
7.
Glow Plug Check.
found in Glow Plug Check.
(WP 0129) Restore machine
to original condition.
2.
If check passed, proceed to
Malfunction 8.
1.
Turn key switch to ON position,
8.
Check For Active
but DO NOT START ENGINE
and Stored DTCs.
(TM 5-3805-294-10). (Volume
5, WP 0794)
2.
Read DTCs. Note any stored
or active DTCs. (Volume 3,
WP 0362)
3.
Turn key switch to OFF
1.
If any DTC is displayed stored
position (TM 5-3805-294-10).
or active, discontinue this
troubleshooting procedure and
(Volume 5, WP 0794)
perform procedure for stored
or active DTCs. Resolve all
DTCs before continuing this
procedure.
2.
If no DTCs are displayed
active, proceed to Malfunction
9.
1.
Turn key switch to ON position,
9.
Perform Harness
but DO NOT START ENGINE
Diagnostic Mode
(TM 5-3805-294-10). (Volume
Test.
5, WP 0794)
2.
Perform Harness Diagnostic
Test. Note any active DTCs.
(Volume 3, WP 0345)
0115-3