TM 5-3805-294-23-1
0115
Table 1. Engine Cranks/Will Not Start - Continued.
Test or Inspection
Corrective Action
Malfunction
3.
Turn key switch to OFF
1.
If any DTCs were displayed
position (TM 5-3805-294-10).
active during Harness
Diagnostic Mode Test,
(Volume 5, WP 0794)
discontinue this
troubleshooting procedure and
perform procedure for active
DTC(s). Resolve all DTCs
before continuing this
procedure.
2.
If no DTCs were displayed
active, proceed to Malfunction
10.
Perform Low-Pressure Fuel
1.
If test failed, repair faults found
10.
Low-Pressure Fuel
Supply System Test.
in Low-Pressure Fuel Supply
Supply System
Test.
System Test. (WP 0131)
Restore machine to original
condition.
2.
If test passed, proceed to
Malfunction 11.
Perform High-Pressure Fuel
1.
If test failed, repair faults found
11.
High-Pressure Fuel
Supply System Test.
in High-Pressure Fuel Supply
Supply System
Test.
System Test. (WP 0130)
Restore machine to original
condition.
2.
If test passed, proceed to
Malfunction 12.
Perform Fuel Supply Quality
1.
If fuel quality is not acceptable,
12.
Fuel Supply
repair faults found in Fuel
Quality.
Check. (WP 0128)
Supply Quality Check.
(WP 0128) Restore machine
to original condition.
2.
If fuel quality was acceptable,
proceed to Malfunction 13.
1.
Turn key switch to ON position,
13.
Pump Position and
but DO NOT START ENGINE
Crank Position
(TM 5-3805-294-10). (Volume
Signal Test.
5, WP 0794)
2.
Select Readings and select
Connect to Model(s). (Volume
3, WP 0363)
0115-4