TM 5-3805-294-23-1
0115
Table 1. Engine Cranks/Will Not Start - Continued.
Test or Inspection
Corrective Action
Malfunction
12.
Select Yes to terminate your
readings connection. (Volume
3, WP 0363)
13.
Turn key switch to OFF
1.
If the data points were as
position (TM 5-3805-294-10).
indicated, proceed to
Malfunction 16.
(Volume 5, WP 0794)
2.
If the data points were not as
indicated, proceed to
Malfunction 14.
1.
Disconnect engine wiring
14.
Check For Crank
harness connector X01 from
Sensor Pattern
crankshaft position sensor
Problem.
(Volume 5, WP 0800, Figure
82) and secure connector
away from rotating
components.
2.
Turn key switch to ON position,
crank engine for 30 seconds.
(TM 5-3805-294-10). (Volume
5, WP 0794)
3.
Turn key switch to OFF
position (TM 5-3805-294-10).
(Volume 5, WP 0794)
4.
Reconnect engine wiring
1.
If engine started, discontinue
harness connector X01 to
this troubleshooting procedure
crankshaft position sensor.
and perform procedure for
(Volume 5, WP 0800, Figure
DTC 637.02 (WP 0057) as
82)
though DTC was active.
2.
If engine did not start, proceed
to Malfunction 15.
1.
Disconnect engine wiring
15.
Check For High-
harness connector X02 from
Pressure Fuel
high-pressure fuel pump
Pump Position
position sensor. (Volume 5,
Pattern Problem.
WP 0800, Figure 83)
2.
Turn key switch to ON position,
crank engine for 30 seconds.
(TM 5-3805-294-10). (Volume
5, WP 0794)
3.
Clear and refresh DTCs.
(Volume 3, WP 0362)
0115-7