TM 5-2420-230-24-1
12-9. NATO SLAVE RECEPTACLE REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Equipment Conditions
None
TM or Para
Condition Description
Vehicle positioned on level
Tools and Special Tools
ground.
Tool kit, general mechanics, Item 38, Appendix B
Parking brake applied.
Engine shut OFF.
Materials/Parts
Nut, self-locking, Item 108, Appendix D (4)
Electrical master switch OFF.
Tags, identification, Item 63, Appendix C
"Do Not Operate" tag attached
Ties, cable, Item 68, Appendix C
to ignition switch.
Washer, lock, Item 289.2, Appendix D (2)
Drawings Required
Personnel Required
TM 5-2420-230-24P Figure 44
MOS 62B, Construction Equipment Repairer
References
Estimated Time to Complete
None
Refer to MAC in Appendix B
a. Removal.
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment and injury or death to personnel may occur.
NOTE
Tag all wires and note their positions before removal.
Remove cable ties as necessary.
(1)
Remove screw (1), lockwasher (2), and positive (+) battery cable (3). Discard lockwasher.
(2)
Remove screw (4), lockwasher (5), and negative (-) battery cable (6). Discard lockwasher.
(3)
Remove four self-locking nuts (7), washers (8), and bolts (9).
(4)
Remove NATO slave receptacle (10).
Change 1