TM 5-2420-230-24-1
NOTE
Wire and seal should be positioned so larger wings of terminal will crimp around seal and smaller
wings will crimp around exposed bare wire.
(e)
Position wire (4) in terminal (5).
(f)
Press handles of crimp tool together until ratchet releases and crimp is complete.
(g)
Push new terminal (5) and wire (4) through connector (1) into cavity (3) until seated.
(h)
Close two secondary locks (2) on connector (1).
(i)
Connect connector (1).
g. Group II Terminal Repair.
(1)
Disassembly.
NOTE
Connector is removed by gently pulling
up on clip and pulling on connector.
All Group II connectors are repaired the
same way. Number of wires in connector
may vary.
Both halves of the connector are repaired
the same way.
(a)
Disconnect connector (1).
(b)
Unlatch and remove two secondary
locks (2) on connector (1).
Change 1
12-55