TM 5-2420-230-24-1
Tip of removal tool is very sharp. Use caution when using tool. Failure to comply may result in injury
to personnel.
(c)
Insert removal tool into terminal connector cavity (3) until seated.
(d)
Pull wire (4) back through connector (1) and removal tool.
NOTE
Do Step (e) only if connector is still attached to wire.
Make cut directly behind damaged terminal.
(e)
Cut off damaged terminal (5) and wire seal (6). Discard terminal and seal.
(2)
Assembly.
Strip wire after placing it through seal to
prevent damage to individual strands.
(a)
Insert 1 in. (25 mm) of wire (4)
through new wire seal (6).
(b)
Strip end of wire (4) leaving 0.25 in.
(6 mm) of bare wire.
Change 1
12-56