TM 5-2420-230-24-1
a. Removal.
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment and injury or death to personnel may occur.
NOTE
Tag all wires and note their positions before removal.
Remove cable ties as necessary.
Ensure all wires are disconnected and cleared before removal.
This task replaces all harnesses; use steps as required.
(1)
Remove eight screws (1) from left dash panel (2).
(2)
Remove five screws (3) from center dash panel (4).
(3)
Remove eight screws (5) from right dash panel (6).
(4)
Remove left dash panel (2), center dash panel (4), and right dash panel (6) from frame.
(5)
Disconnect electrical connectors (7) from left dash panel harness.
(6)
Disconnect electrical connectors (8) from center dash panel harness.
(7)
Disconnect electrical connectors (9) from right dash panel harness.
(8)
Disconnect electrical connectors (10) and (11) from PDP.
(9)
Disconnect electrical connector (12) from EGS.
(10) Remove harness from cab.
Change 1
12-86