TM 5-2420-230-24-1
b. Installation.
No smoking, flames, sparks, or glowing or hot objects allowed within 50 ft. (15 m) of vehicle. Fire
or explosion may cause personal injury or death.
Fuel and oil are slippery and can cause falls. To avoid injury, wipe up spilled fuel or oil with rags.
To prevent possible injury, wear gloves and protective eye equipment when handling fuel. Failure
to comply may result in injury or death to personnel.
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive
electrical circuits, a direct short may result. Damage to equipment and injury or death to personnel
may occur.
Steps in the installation of the sender unit are the reverse of those in the removal procedure with attention given to the
following points:
(1)
Handle sender unit carefully.
(2)
Use new gasket and lockwashers when reinstalling sender unit in fuel tank.
c. Follow-On Maintenance.
(1)
Start engine and functionally check for operation of fuel gauge (TM 5-2420-230-10).
(2)
Check for leaks.
(3)
Shut OFF engine (TM 5-2420-230-10).
(4)
Replace fuel tank step plate (Para 13-14).
(5)
Deleted.
END OF TASK
12-38. REVERSE ALARM REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Equipment Conditions
None
TM or Para
Condition Description
Vehicle positioned on level
ground.
Tools and Special Tools
Tool kit, general mechanics, Item 38, Appendix B
Parking brake applied.
Engine shut OFF.
Electrical master switch OFF.
Materials/Parts
Ties, cable, Item 68, Appendix C
"Do Not Operate" tag attached
to ignition switch.
Personnel Required
MOS 62B, Construction Equipment Repairer
Drawings Required
TM 5-2420-230-24P Figure 56
References
None
Estimated Time to Complete Task
Refer to MAC in Appendix B
Change 1