TM 5-2420-230-24-1
a. Removal.
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment and injury or death to personnel may occur.
NOTE
Remove cable ties as necessary.
(1)
Remove two screws (1) and washers (2).
(2)
Remove reverse alarm (3).
(3)
Disconnect electrical connector (4).
b. Installation.
NOTE
Install cable ties as necessary.
(1)
Install the reverse alarm (3) on vehicle with
two washers (2) and screws (1).
(2)
Connect electrical connector (4).
c. Follow-On Maintenance.
(1)
Start vehicle and test reverse alarm
(2)
Shut OFF engine (TM 5-2420-230-10).
(3)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
12-39. DASH PANEL WIRING HARNESS REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Test Equipment
None
TM or Para
Condition Description
Vehicle positioned on level
ground.
Tools and Special Tools
Parking brake applied.
Tool kit, general mechanics, Item 38, Appendix B
Engine shut OFF.
Electrical master switch OFF.
Materials/Parts
"Do Not Operate" tag attached
Tags, identification, Item 63, Appendix C
to ignition switch.
Ties, cable, Item 68, Appendix C
Inclinometer and bracket
removed (center dash panel
Personnel Required
only).
MOS 62B, Construction Equipment Repairer
Drawings Required
References
TM 5-2420-230-24P Figure 68
None
Estimated Time to Complete Task
Refer to MAC in Appendix B
12-85
Change 1