TM 5-2420-230-24-1
12-42. MARKER LIGHT ASSEMBLY REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Equipment Conditions
None
TM or Para
Condition Description
Vehicle positioned on level
ground.
Tools and Special Tools
Tool kit, general mechanics, Item 38, Appendix B
Parking brake applied.
Engine shut OFF.
Electrical master switch OFF.
Materials/Parts
None
"Do Not Operate" tag attached
to ignition switch.
Personnel Required
Drawings Required
MOS 62B, Construction Equipment Repairer
TM 5-2420-230-24P Figure 57
References
Estimated Time to Complete Task
None
Refer to MAC in Appendix B
a. Removal.
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment and injury or death to personnel may occur.
NOTE
Both sides are removed and installed the same way. Right, rear side is shown.
(1)
Remove screw (1) and lens (2).
(2)
Remove two screws (3) and wires (4).
(3)
Remove two nuts (5), washers (6) and bolts (7).
(4)
Remove marker light (8) from vehicle.
b. Installation.
(1)
Install two wires (4) and screws (3) in marker
light (8).
(2)
Position marker light (8) in vehicle.
(3)
Install two bolts (7), washers (6), and nuts (5).
(4)
Install lens (2) and screw (1).
Change 1