TM 5-2420-230-24-1
c. Type 2 Removal.
Using a 1/8 in. drill bit, remove four rivets (1) and
data plate (2) from frame (3). Discard rivets.
d. Type 2 Installation.
Install data plate (2) on frame (3) with four new
rivets (1).
e. Type 3 Removal.
Pry data plate (1) away from frame (2).
f. Cleaning.
(1)
Ensure surface is free of any dirt or debris.
Degreasing Solvent (MIL-PRF-680) is
toxic and flammable. Keep away from
heat or flame. Never smoke when using
solvent. The flashpoint for Type II
Degreasing Solvent is 141 F (61 C).
Wear protective goggles, face shield, and
gloves; use only in a well-ventilated area;
avoid contact with skin, eyes, and clothes;
and do not breathe vapors. Failure to
comply may result in injury or death to
personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical
help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, immediately
flush eyes with water and get immediate medical attention.
Adhesives, solvents, and sealing compounds burn easily and give off vapors that are harmful to the
skin and clothing. To avoid injury or death, keep away from open fire when using these materials,
and use only in well-ventilated areas. If adhesives, solvents, or sealing compounds contact the skin
or clothing, wash immediately with soap and water, and rinse thoroughly. Failure to comply may
result in injury or death to personnel.
(2)
Clean with lint-free cloth and degreasing solvent.
g. Type 3 Installation.
Peel paper off data plate (1) and place on frame (2).
h. Follow-On Maintenance.
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
Change 1
13-20
