TM 5-2420-230-24-1
f. Rear Shaft Installation.
NOTE
The steering shaft slip joints are precisely
aligned. It is important that alignment is
maintained during maintenance.
If steering shaft slip joint was separated,
ensure scribe marks on slip and joint are
aligned.
(1)
Position rear steering shaft (18) through crew
compartment.
NOTE
Ensure half-moon groove is aligned with bolt
hole and U-joint clamps.
(2)
Install U-joint (16) on miter box shaft (17).
(3)
Install bolt (13), two washers (14), and new self-locking nut (15) on U-joint (16). Tighten bolt to 98 lbf/ft
(133 Nm).
Change 1
5-32