TM 5-2420-230-24-1
a. Removal.
(1)
Remove three self-locking nuts (1), washers (2), studs (3), and miter box (4) from mounting plate (5). Discard
self-locking nuts (1).
(2)
If required, remove studs (3) from miter box (4).
b. Installation.
Adhesives, solvents, and sealing compounds burn easily and give off vapors that are harmful to the
skin and clothing. To avoid injury or death, keep away from open fire when using these materials, and
use only in well-ventilated areas. If adhesives, solvents, or sealing compounds contact the skin or
clothing, wash immediately with soap and water, and rinse thoroughly. Failure to comply may result in
injury or death to personnel.
NOTE
Screw studs into miter box until studs bottom out in miter box holes.
(1)
If required, apply loctite 243 to three studs (3) and install miter box (4), three studs (3), washers (2), and new
self-locking nuts (1) on mounting plate (5).
(2)
Grease miter box (TM 5-2420-230-10).
c. Follow-On Maintenance.
(1)
Install nose cone (Para 13-18).
(2)
Connect steering shaft to miter box (Para 5-14).
END OF TASK
Change 1
5-36