TM 5-2420-230-24-1
19-9. A/C RECEIVER-DRIER REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
References
None
None
Equipment Conditions
Tools and Special Tools
TM or Para
Condition Description
Tool kit, general mechanics, Item 38, Appendix B
FEL arms raised and
maintenance arm installed.
Materials/Parts
Hood raised.
Cap and plug set, Item 4, Appendix C
Remove A/C pressure switch.
Tags, identification, Item 63, Appendix C
Ties, cable, Item 68, Appendix C
Drawings Required
TM 5-2420-230-24P Figure 189
Personnel Required
MOS 62B, Construction Equipment Repairer
Estimated Time to Complete Task
Refer to MAC in Appendix B
a. Removal.
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment and injury or death to personnel may occur.
NOTE
Tag all hoses, wires, and tubes and note their positions before removal.
Cap and plug all tubes, hoses, and fittings upon removal.
Remove cable ties as necessary.
Ensure all hoses, wires, and tubes are disconnected and clear before removal.
(1)
Remove two hoses (1) from receiver-
drier (2). Inspect O-rings on hoses. Replace
any hose with a damaged O-ring.
(2)
Loosen hose clamp (3) and remove receiver-
drier (2) from bracket (4).
Change 1