TM 5-2420-230-24-1
19-8. A/C COMPRESSOR REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Equipment Conditions
None
TM or Para
Condition Description
Nose cone removed.
Tools and Special Tools
Steering wheel turned full left.
Tool kit, common no. 2, Item 36, Appendix B
Right front fender removed (do
Tool kit, general mechanics, Item 38, Appendix B
not remove MLC placard or
grab handle).
Materials/Parts
Cap and plug set, Item 4, Appendix C
Drive belt removed (from A/C
Nut, self-locking, Item 111, Appendix D (4)
compressor pulley only).
Oil, lubricating, Item 41.1, Appendix C
A/C receiver-drier removed.
Tags, identification, Item 63, Appendix C
Ties, cable, Item 68, Appendix C
Drawings Required
Washer, lock, Item 282, Appendix D (3)
TM 5-2420-230-24P Figure 189
Personnel Required
Estimated Time to Complete Task
MOS 62B, Construction Equipment Repairer (2)
Refer to MAC in Appendix B
References
None
a. Removal.
NOTE
Tag all hoses, wires, and tubes and note
their positions before removal.
Cap and plug all tubes, hoses, and fittings
upon removal.
Remove cable ties as necessary.
Ensure all hoses, wires, and tubes are
disconnected and clear before removal.
(1)
Disconnect two hoses (1) from
compressor (2).
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry or tools contact
positive electrical circuits, a direct short may
result. Damage to equipment and injury or
death to personnel may occur.
(2)
Disconnect harness (3) from compressor (2).
Change 1