TM 5-3805-294-23-1
0135
Table 1. DTC 13308.02 - Abnormal CAN Communication - Continued.
Test or Inspection
Corrective Action
Malfunction
Measure resistance (Volume
1.
If continuity is present,
7.
Open Circuit
proceed to Malfunction 10.
Between Connector
3, WP 0369) between
X20 Socket 7 And
connector X20 socket 7
2.
If continuity is not present,
Connector X34
(Volume 5, WP 0800, Figure
proceed to Malfunction 8.
Socket 5.
87) and connector X34 socket
5. (Volume 5, WP 0800,
Figure 98) Note reading.
1.
Disconnect connector X24.
8.
Connector X24 Has
Damage or Loose
(Volume 5, WP 0800, Figure
Sockets/Pins.
91)
2.
Visually inspect connector X24
1.
If damaged or has loose
for damage or loose sockets/
sockets/pins, replace monitor
pins.
controller wiring harness for
pin side (Volume 4, WP 0519)
or replace cab wiring harness
for socket side. (Volume 4,
WP 0504) Restore machine to
original condition.
2.
If not damaged and does not
have loose sockets/pins,
proceed to Malfunction 9.
Measure resistance (Volume
1.
If continuity is present, replace
9.
Open Circuit
cab wiring harness. (Volume 4,
Between Connector
3, WP 0369) between
X20 Socket 7 And
connector X20 socket 7
WP 0504) Restore machine to
Connector X24 Pin
original condition.
(Volume 5, WP 0800, Figure
1.
87) and connector X24 pin 1.
2.
If continuity is not present,
(Volume 5, WP 0800, Figure
replace monitor controller
91) Note reading.
wiring harness. (Volume 4,
WP 0519) Restore machine to
original condition.
Measure resistance (Volume
1.
If continuity is present,
10.
Open Circuit
proceed to Malfunction 13.
Between Connector
3, WP 0369) between
X20 Socket 6 And
connector X20 socket 6
If continuity is not present,
2.
Connector X34
(Volume 5, WP 0800, Figure
proceed to Malfunction 11.
Socket 11.
87) and connector X34 socket
11. (Volume 5, WP 0800,
Figure 98) Note reading.
1.
Disconnect connector X24.
11.
Connector X24 Has
Damage or Loose
(Volume 5, WP 0800, Figure
Sockets/Pins.
91)
0135-3