TM 5-3805-294-23-1
0135
Table 1. DTC 13308.02 - Abnormal CAN Communication - Continued.
Test or Inspection
Corrective Action
Malfunction
Measure resistance (Volume
1.
If continuity is present, replace
15.
Short Circuit
monitor controller wiring
Between Connector
3, WP 0369) between
harness. (Volume 4,
X20 Socket 7 And
connector X20 socket 7
Ground With
WP 0519) Restore machine to
(Volume 5, WP 0800, Figure
Connector X24
original condition.
87) and a known good ground.
Disconnected.
Note reading.
2.
If continuity is not present,
replace cab wiring harness.
(Volume 4, WP 0504) Restore
machine to original condition.
Measure resistance (Volume
1.
If continuity is present,
16.
Short Circuit
proceed to Malfunction 17.
Between Connector
3, WP 0369) between
X20 Socket 6 And
connector X20 socket 6
2.
If continuity is not present,
Ground.
(Volume 5, WP 0800, Figure
proceed to Malfunction 19.
87) and a known good ground.
Note reading.
1.
Disconnect connector X24.
17.
Connector X24 Has
Damage or Loose
(Volume 5, WP 0800, Figure
Sockets/Pins.
91)
2.
Visually inspect connector X24
1.
If damaged or has loose
for damage or loose sockets/
sockets/pins, replace monitor
pins.
controller wiring harness for
pin side (Volume 4, WP 0519)
or replace cab wiring harness
for socket side. (Volume 4,
WP 0504) Restore machine to
original condition.
2.
If not damaged and does not
have loose sockets/pins,
proceed to Malfunction 18.
Measure resistance between
1.
If continuity is present, replace
18.
Short Circuit
connector X20 socket 6
monitor controller wiring
Between Connector
harness. (Volume 4,
X20 Socket 6 And
(Volume 5, WP 0800, Figure
Ground With
87) and a known good ground.
WP 0519) Restore machine to
Connector X24
Note reading.
original condition.
Disconnected.
If continuity is not present,
2.
replace cab wiring harness.
(Volume 4, WP 0504) Restore
machine to original condition.
0135-5