TM 5-3805-294-23-1
0135
Table 1. DTC 13308.02 - Abnormal CAN Communication - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Visually inspect connector X24
1.
If damaged or has loose
for damage or loose sockets/
sockets/pins, replace monitor
pins.
controller wiring harness for
pin side (Volume 4, WP 0519)
or replace cab wiring harness
for socket side. (Volume 4,
WP 0504) Restore machine to
original condition.
2.
If not damaged and does not
have loose sockets/pins,
proceed to Malfunction 12.
Measure resistance (Volume
1.
If continuity is present, replace
12.
Open Circuit
cab wiring harness. (Volume 4,
Between Connector
3, WP 0369) between
X20 Socket 6 And
connector X20 socket 6
WP 0504) Restore machine to
Connector X24 Pin
original condition.
(Volume 5, WP 0800, Figure
8.
87) and connector X24 pin 8.
2.
If continuity is not present,
(Volume 5, WP 0800, Figure
replace monitor controller
91) Note reading.
wiring harness. (Volume 4,
WP 0519) Restore machine to
original condition.
Measure resistance (Volume
1.
If continuity is present,
13.
Short Circuit
proceed to Malfunction 14.
Between Connector
3, WP 0369) between
X20 Socket 7 And
connector X20 socket 7
2.
If continuity is not present,
Ground.
(Volume 5, WP 0800, Figure
proceed to Malfunction 16.
87) and a known good ground.
Note reading.
1.
Disconnect connector X24.
14.
Connector X24 Has
Damage or Loose
(Volume 5, WP 0800, Figure
Sockets/Pins.
91)
2.
Visually inspect connector X24
1.
If damaged or has loose
for damage or loose sockets/
sockets/pins, replace monitor
pins.
controller wiring harness for
pin side (Volume 4, WP 0519)
or replace cab wiring harness
for socket side. (Volume 4,
WP 0504) Restore machine to
original condition.
If not damaged and does not
2.
have loose sockets/pins,
proceed to Malfunction 15.
0135-4